Cummins Engine Currently, on the basis of compression type engine braking, more intelligent two-stage engine braking has been developed. Tianlong sail version 13L comes standard with two-stage engine brake (compression release type) without exhaust brake. This braking configuration enables cardmates to have greater braking force and stable downhill speed under no-load, small-gradient, wet-slip road conditions, and to maximize economic efficiency under the premise of ensuring safety. Including large slopes and other situations.
The benefits of two-stage engine braking: According to the required speed and braking force, select the appropriate braking gear to ensure that the vehicle downhill controllable, effectively reducing the braking distance, to avoid wheel brake failure, while improving transport efficiency and reducing maintenance Cost, and can remove the water heater, improve fuel economy.
Reasons without exhaust brake: The engine brake effect is better than the exhaust brake; At the same time, the models with engine brake and exhaust brake are found. The exhaust brake will produce large exhaust back pressure, and the engine performance The effect is not as good as single-engined braking.
The safety issue has always been a part of the user's concern for vehicle performance. Dongfeng Cummins has also been producing safer products for consumers to choose from. At the same time, Kangkang believes that as long as the proper use of engine brakes can make you safe save money.
Tension Machine is a kind of feedthrough pre-tensioing. It is also called Spun Pile tension jack machine, Pole Tension Machine, prestressed tension machine etc. It is the neccesary equipment to produce Pre-stressed Concrete Spun Pile and prestressed concrete pole products. As the end of the tension rod is connected to the anchor with thread, it can be applied to various forged anchors, chilled iron anchor used for stayed-cable bridge and other similar anchors, as well as pre-tension pulling for pipes. In accordance with actual requirement.
Tension jigs are normal 7parts or 5 parts for re-pretress pole and pile, including tension nut, tension rod, support plate, tension plate, connect plate, joint ring, fixed plate etc. we can customize for you. It meet the wire and pc bar's requirement.
If you have any questions, please contact with us. Welcome you can visit our Factory.For inqury,Please send mail directly to us.
Tension Machine,Tension Jig,Pile Tension Jig ,Pole Tension Machine
Jiangsu Haiheng Building-Materials Machinery Co.,Ltd , https://www.jshaiheng.com