When installing the instrument, the user must obey the installation rules, pay attention to some details, avoid the performance degradation of the instrument caused by improper installation, and even shorten the service life of the instrument. What should the reducer pay attention to? The following Xiaobian gives you a detailed introduction about deceleration. Three things that should be noted when installing the machine:
1, no hammering:
The method of direct hammering cannot be adopted when installing the output shaft of the reducer, such as the coupling, pulley, sprocket, etc. Because the output shaft structure of the reducer cannot withstand the axial hammering, the shaft end screw hole can be screwed in. Screw into the coupling.
2, timely replacement of lubricants, pay special attention to the first time:
Should pay special attention to the first oil change, reducer in the first run 300 to 400 hours should be replaced after the replacement of lubricating oil, after every 1500 to 2000 hours to replace the lubricating oil. In addition, in the harsh working environment, high temperature and dusty working conditions, the lubricant should be inspected once every two weeks. It is found that there is dirt in the lubricant and the lubricant is replaced to keep the lubricant clean and extend the use of the reducer. Life, improve economic efficiency.
3, must install the vent cap (exhaust screw plug):
Before use, the plug at the highest position should be replaced with an exhaust screw plug to ensure that the reducer runs out of gas during operation. If it is not replaced in time, the reducer will run for a long time, which will cause the gas in the reducer to swell and the oil leak in the reducer.
The above content is the three major issues that Xiaobian should pay attention to when installing the reducer. We can use the above steps as a reference, hoping to help everyone use the instrument better.
The most important parts of the engine is camshaft, crankshaft, connecting rod, cylinderblock and cylinderhead. The cylinder is the main part to connect all the parts, the crankshaft receives torque when transmiss the power, the connecting rod convert the reciprocating linear motion of the piston into the rotary motion of the crankshaft, and the camshaft is the main component of the gas distribution system. and the cylinder head is to seal the cylinder. For kubota engine, we can offer Engine Parts for v2203,v3300,v2003,v2403,v1505,D1105,D905,Z482.
Engine Parts For Kubota,Kubota Engine Components,Kubota Engine Parts,Kubota Tractor Engine Parts
Hangzhou Holdwell Mechanical&Electrical Co.,LTD , http://www.holdwellparts.com