Although pneumatic three-way parts are installed on the pneumatic equipment, if the working environment is poor, the pneumatic system cannot be ensured to work stably and reliably. It is necessary to strengthen the pre-purification treatment of the air source to better meet the requirements of use. If unpurified compressed air is used, the pneumatic equipment will not work properly. However, in practical applications, the purification of gas sources is often overlooked. Some people think that as long as there is compressed air, the pneumatic equipment can work. Therefore, some units use the unpurified air source directly from the air compressor station when applying pneumatic equipment. Obviously, this is very unscientific. Others are pneumatic three-way parts (filters, pressure reducing valves and oil misters) installed on the pneumatic equipment, so it is safe to use the air supply.
Some suggestions for purifying the gas source. First, the air compressor should be placed in a clean environment. There should be cleaning measures for the air compressor room. Even if it is for mobile or small air compressors, do not place it casually; avoid dust, humidity and other occasions. The volatile matter that has a corrosive effect on the rubber seal should be avoided to ensure the quality of the inhaled air. Second, the pipeline for conveying the compressed air should be installed in a regular piping manner. The compressed air output from the air compressor is cooled down by the cooling system. Therefore, the lowest end of the main pipeline should be arranged to discharge water regularly, especially before the power is turned on, so as to avoid the compressed air when starting up. Bring into the pneumatic system; third, when it is necessary to remove dust and lack high-quality filter device, a simple filter can be used instead, and good results can be obtained.
CNC Angle Puching Mraking Shearing Line
1.Adopt CNC technology, servo motor infeeding, with high efficiency, stable workpiece precision.
2.Key hydraulic, pneumatic and electric parts are all world famous brand.
3.Easy programming and can directly use the program data made by lofting software.
4.Computer with Chinese/English interface, easy operation, and can display the drawing of
workpiece.
5.All marking, punching and shearing in automatic completeness, all finished angles can be
unloaded by pneumatic turnover device so as to lighten the working strength.
6.Only need to input size of workpiece, diameter of holes, stadia and quantity of workpiece
when edit program.
7.The angle line installs supporting & pressing device to meet the requirements of processing
angles with bigger bending.
8.Marking unit adopts closed frame with good rigidity. Marking stadia can be set at will.
9.With avoided shearing functions, so as to process fixed-length angles.
10.With self-diagnosis failures function.
CNC Angle Punching Marking Shearing Line
Shearing Line,Cnc Angle Punching Marking Shearing Line,Angle Steel Bending Machine,Cnc Miter Saw
Shandong XingTian Sunshine Intelligent Equipment Co., Ltd. , http://www.cnsunshinecnc.com